Your water heater is one rather used and much more costly appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating and costs.

Regular flushing of your water heater is among the single most important step you can take to prolong its service life this particular save energy. In a period of time, sediments amass in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regions of the country, the normal water heater lasts 3-5 years. Regularly flushing your water heater can double daily life of your water heater from 3-5 to 7-10 years. Are investigating costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater ‘s very important in today’s economy. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a nights.

To drain your water heater, you can find should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to water heater. Next, close the water supply valve located more than a water inlet line going into your water heater. Then you’re connect a garden hose to the drain valve located towards the bottom of the heater tank. Open the drain and allow it to run until all of the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until drinking water flows out gradually. This will allow air to vent from the heater and the water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so may be less corrosive to your plumbing system, particularly in areas possess hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and merchandise to work for you.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2